Model H-810 High Volume Air Sampler
The Model H-810 is a dependable, lightweight, grad sampler which incorporates the reliability of the model H-809V with a Air Volume Totalizer.
This microprocessor based unit is designed to eliminate the use of rotameters and mechanical time meters, simplifying air sampling procedures while adding significantly higher accuracy to air sampling data.
Air Volume Totalizer
This portion of the sampler is composed of an enclosed air-turbine which rotates at speeds proportional to the velocity of the sampled air. The turbine’s rotation is sensed by a reflective sensor/breaker disk. The microprocessor converts the signal to volume and displays the FLOW RATE, TOTAL VOLUME and ELAPSED TIME on the LCD readout.
Specifications
Operational Range/Accuracy Up to 99,999 cubic feet or liters ±5%
Readout of Totalizer LCD: 2 Lines, 16 Characters, backlit. Continuous display of cumulative volume, flow rate and elapsed time. Battery backed to recall sample data in power loss event.
Calibration Easily settable calibration through an on-board membrane keypad with password. Calibrates in <2 minutes.
Operating Voltage 95 to 135V, 50-60Hz, 1 Phase 8 Amps (205 to 245V, 50Hz, 1 Phase 4 Amps)
Dimensions/Weight 8 1/2” wide, 7 1/2” deep, 9” high (21.6 cm X 19 cm X 22.9 cm) 8.5 lbs (4 kg)
Air Mover/Motor Internally mounted, two stage turbine blower with 1 HP self cooled motor
Keypad Start /Stop Keys: Run pre-set sample volume. Unit Key : Toggles display cubic feet/liters.
Set Key: Sets unit to run in time/vol. mode. Enter Key: Enters target volume and time. Keypad Security: All keys locked in calibration mode except Start, Stop, and Unit Keys.
HIGH ACCURACY, RUGGED, LCD DISPLAY, Elapsed Sample Time, Flow Rate, Total Volume, MICROPROCESSOR BASED, BATTERY BACKED MEMORY, RECESSED FLOW ADJUST, MINIMUM TRAINING NEEDED
ALSO AVAILABLE
Model H-810DC 12/24 VDC with jumper cables
Model TRP-2 tripod for breathing zone sampling
TYPICAL MAXIMUM FLOW RATES FOR VARIOUS COMBINATIONS OF FILTERS AND CARTRIDGES
|
TYPICAL MAXIMUM FLOW RATES FOR VARIOUS COMBINATIONS OF FILTERS AND CARTRIDGES
|
a |
a |
a |
|
CARTRIDGE
|
HD-2064 FILTER47mm DIAMETER
|
LB-5211 FILTER47mm DIAMETER
|
GELMAN AE FILTER47mm DIAMETER
|
| a |
FLOW RATE (CFM)
|
FLOW RATE (CFM)
|
FLOW RATE(CFM)
|
|
CP-100
|
4.6
|
3.4
|
3.3
|
|
CP-200
|
8.9
|
4.9
|
5.0
|
|
BG-300
|
8.1
|
4.8
|
4.8
|
|
GY-130
|
5.6
|
3.7
|
3.9
|
